Have you inspected your Garage Door lately?

By: Ricardo Aquino

The garage door is typically the largest moving part in your home and is probably used every day. With normal use, garage door parts can wear out and break, creating potential safety problems. There are a few light maintenance duties and inspections a mechanically inclined person can perform to ensure maximum safety and increase the life of their door.

Check the garage door springs, rollers, hinges and safety devices to be sure they are fastened securely and in proper working order.

Check the balance of the door by lifting it a few feet off the ground and releasing. The door should not travel more than a couple of inches in either direction. If the door drops to the ground then your garage door springs either need adjusting or replacing. When operated manually a garage door should go up and down smoothly.

In the event of spring failure extension springs can cause severe damage if they are not contained. If the door's springs don't already have safety garage door cables installed, now would be a good time to get them installed. Remember even the highest quality springs eventually wear and break.

Replace springs if they show signs of wear such as uneven gaps between the coils, bent or damaged ends.

Inspect the cables for fray. Replace frayed cables immediately. Check the pulleys for nicks or excessive wear that can cause damage to the cable. Replace worn pulleys if necessary.

Verify that the garage door tracks are level and plumb. Track should line up parallel to the door sections without binding. Ensure that the lag screws securing the garage door track brackets to the jambs are secure. Replace bent, missing or rusted lags immediately.

Tighten all hinge and bracket screws, bear in mind that garage door bottom brackets are under extreme tension when the door is closed and can cause serious injury if accidentally or deliberately loosened or removed. Replace bent or broken hinges. Check the door's rollers for excessive wobble and replace as necessary.

All garage door openers manufactured and installed after 1991 are required by law to have a reversing mechanism. Garage door openers manufactured and installed after 1993 are required to have photo eyes connected at the bottom of the track to trigger the reverse mechanism when an infrared beam is broken. A defective or improperly adjusted reversing mechanism on your garage door opener could cause damage, injury and possibly death. Check your door opener regularly to be sure that the reversing mechanism is in proper working order.

Lubricate rollers, hinge pivots, pulleys, torsion springs coils, bearings and the electric opener chain and sprockets.

With periodic inspections and maintenance the average garage door can safely provide many years of trouble free performance.

Niche Article Directory: http://www.thatsmyniche.com

Ricardo Aquino is the owner of Garage Door Parts, LLC - website offers complete line of garage door parts for residential, commercial and industrial applications.

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated